![]() ![]() On the flip side, if your horn is cold, it’s going to lean flat. As a result, the horn is going to tend sharp, so give it some time to cool off. If your horn was out in the trunk on a hot summer day, it might be a bit hot. In addition, you’ll want your horn to reach some equilibrium temperature with the environment. If you tune too early, you may find that your pitch changes as you begin to settle in. Each of these exercises can help you get in a state where you’ll spend the remainder of your rehearsal. If you haven’t been playing much, you might want to do some long tones and lip slurs. After all, it can take some time to settle in for both you and your horn. While you might be tempted to start blowing directly into your tuner, it’s important to warm up first. If you’re looking for a few recommendations, I can put together a nice review, but you really can’t go wrong with Snark SN5X, Korg CA-2, or Korg TM60BK. Finally, they also occasionally have fun features like the ability to be clipped onto surfaces like guitar necks or music stands. In addition, some tuners also combo as metronomes, so you can use the device throughout a practice session. When you buy a tuner, you’ll usually get more options like the ability to change the reference frequency (i.e. If you want to go the extra mile, you can always purchase a professional tuner. For instance, I use InsTuner on iPhone, but there are literally hundreds of options including TonalEnergy, Free Chromatic Tuner, and more. If you’re frugal, most smartphones have free tuner apps. Sure, you could pull up a YouTube video and try to play to some tuning notes, but it’ll be a lot quicker to use a tuner. Step 2: Acquire a TunerĪgain, it may seem obvious, but it’s pretty hard to tune a horn without a proper tuner. For more tips on how to grease a trombone tuning slide, check out my 3-step guide. Finally, work the tuning slide into playing position and wipe away the extra grease. Then, work each tube on individually to spread out the grease. To do that, apply some slide grease to the circumference of each tube. With the tuning slide all clean, you’ll want to get a decent helping of grease on both tubes. For all sorts of tips related to cleaning your trombone, check out my 8-step guide. If you have the tools, now would be a good time to snake out the tuning slide as well. To do that, you’ll not to remove the tuning slide and scrub it down. For instance, you might want to give it a good bath. That said, even if you can move your tuning slide, it’s probably a good idea to clean it up. if that’s the case, you’ll probably want to get it in the shop. After all, if you haven’t been using your tuning slide, it may be stuck. It may seem obvious, but you should make sure you’re able to move your tuning slide first. Step 1: Make Sure Your Tuning Slide Works ![]() Of course, you may skip to steps 3 and 4 if you already have what you need. Sustain, interpret, and adjust as needed.In general, there are four main steps to perform if you want to tune your trombone-especially if you haven’t done it before or don’t do it often: In the remainder of the article, we’ll go into each of these steps in much greater detail. ![]() ![]() With your horn ready to go, blow a few tuning notes (B♭ above the staff) into the tuner and adjust the tuning slide as needed. If so, make sure you get a hold of a tuner. In short, to tune a trombone, you’ll want to make sure your tuning slide works. In this article, we’ll take a look at how to tune a trombone using that tuning slide. While trombones are often joked about as giant tuning slides, they actually have tuning slides of their own. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |